KT Main Casing

(Large Range)

Main casing (Bearing structure) made of extremely thick steel-sheet, resistant to rust, corrosion, chemical agents, solvents, aliphatics and alcohols.

Self-supporting and removable panels provided with holes (buttonholes) for ceiling/wall mounting directly through the main casing.

Pre-cuts slots and prearranged holes to configure the unit on request, to install the accessories, to output for the water connections on the left or right, to reverse the unit even on-site.

Assembled with self-threading screws for fast, total and easy check/maintenance. Reduced sizes, optimised volumes.

Available in a very large range of horizontal and vertical versions.

Available main casings:

Z : Single skin panel made of galvanized steel + internal thermal-acoustic insulation (class M1) of all parts in contact with the coil for all TK -CS/CA models.

P : Single skin panel made of pre-painted steel white RAL9002 colour + internal thermo-acoustic insulation (class M1) of the parts in contact with the coil for TK - VA/HA models.

Back to : KT Standard Fan Coil Units

MKAC - Compressor

All units use low-noise, maintenance free, Hermetic Scroll compressor with low vibration levels, specially optimized for use with R410a refrigerant, selected from world class suppliers. They are equipped with a crankcase electrical heater for the oil, and are internally protected against potential overloading or electrical spikes. The compressors are mounted on special antivibration rubber mounts to eliminate vibration from the unit’s.

MKAC - Hydraulic kit

This versionis equipped with hydraulic kit. It includes : one or two pumps (one as stand-by), expansion vessel, gauses, flow switch, safety valve, air purger, shut off valve and hydraulic circuit insulated. In case of stand-by pump non-return valves are mounted. Relevant electrical circuit. As option, pumps with higher ESP are available.

MKAC - Axial Condenser Fans

All unit fans are of the axial type made of Al/Mg, directly coupled to a three phase electric motor with external rotor, 6 poles, internally protected against potential overheating, silent and suitable for outdoor installation. Due to the sophisticated aerodynamic design of the blades and inlet cones, as well as the perfect static and dynamic balancing, their operation is completely vibration-tree.The fan-motor assembly has a protective grid against accidental contact with moving parts, which is designed according to lS0 regulations. Fan motors are of the external rotor type, aerodynamically shaped so as not to interfere with the airflow.

Download

Download our latest Technical Data brochures & manuals